Denmark vs Poland Grading System

How does the Denmark grading system work?

Denmark uses a 7-step scale with only these valid values: -3, 0, 2, 4, 7, 10, 12. No values in between exist. Minimum pass is 2.

⚠️ Danish grades use ONLY these values: -3, 0, 2, 4, 7, 10, 12. No in-between values. Minimum pass is 2.

How does the Poland grading system work?

Polish universities use a 2–5 scale where 3 is minimum pass. Plus grades (3.5, 4.5) are common.

Do Denmark and Poland mark to the same standard?

No — and it is the difference in marking culture, not the arithmetic, that makes a direct comparison mislead. Here is how each country actually uses its own scale.

What a good grade means in Denmark

A 12 is defined as an excellent performance with no or only insignificant weaknesses, and it is awarded sparingly — the scale was explicitly designed to stop grade inflation by making the top grade demanding and the steps between grades wide. A 10 is a very good result, and a 7 is a solid one that a US reader would wrongly dismiss as a C. Because the values are discrete and unevenly spaced, converting a Danish average by proportion produces a number that means nothing.

What a good grade means in Poland

The usable range runs from 3 to 5, so only two points separate a bare pass from the maximum and each half-step carries real weight. A 4.0 is a good, solid degree rather than the mediocre "80%" it becomes under proportional conversion. Polish universities are increasingly familiar to admissions offices across Europe through Bologna and ECTS, but a transcript sent outside Europe benefits from the grading key that explains what a 4.5 actually represents.

Will a grade from Denmark get you into Poland?

We do not yet hold published entry requirements for Poland, so we do not compare your grade against a bar we cannot cite. The conversion above still tells you how your result reads in Poland terms.

Danish 12 → 4.0 GPA. 10 → approximately 3.5. 7 → approximately 3.0.

What goes wrong converting grades from Denmark to Poland?

The pass marks differ — 2 in Denmark against 3.0 in Poland — so the two scales have different usable ranges and the middle of one is not the middle of the other.

Mistakes specific to Denmark grades

• Treating the seven-point scale as continuous. There is no 8 or 9, so averages and interpolations misrepresent the result.
• Reading a 7 as mediocre. It maps to an ECTS C, which describes good work rather than a barely adequate performance.
• Assuming 02 is a typo. It is the minimum pass grade, written with the leading zero.

What should you do next, applying from Denmark to Poland?

1. Check the course, not the country. Entry requirements are set per programme and revised every cycle. We hold no published national bar for this destination, so the course page is the only figure that binds.
2. Check whether an evaluation is even required. Unlike the US and Canada, Poland universities commonly assess foreign transcripts in-house. Confirm on the course page before paying for a report you may not need.
3. Get your documents moving early. Universities normally require your transcript sent directly by your institution rather than as a copy from you, which takes longer than most applicants expect.
4. Read both systems in full. How Denmark grading works · How Poland grading works

What do these grading terms mean?

GPA (Grade Point Average)

The US way of expressing an overall grade, on a 0–4.0 scale where 4.0 is the top — so a 4.0 is roughly what a 90–100% or a First Class would be elsewhere.

Percentage scale

A 0–100 marking scale — but the numbers are not comparable across countries: 70% is an outstanding result in the UK and a modest one in India.

Credits / credit hours

A measure of how much a subject counts toward your degree — bigger subjects carry more credits and pull your average further.

Transcript

The official document from your university listing every subject you took and the grade you got — not the same as your degree certificate, and universities abroad want both.

Frequently asked questions