Philippines vs Switzerland Grading System

How does the Philippines grading system work?

Most Philippine universities use an inverted 1.0–5.0 scale where 1.0 is the highest grade and 3.0 is the minimum pass. Some US-affiliated institutions use a regular 4.0 GPA scale instead.

⚠️ Most Philippine universities use an INVERTED scale — 1.0 is BEST, 3.0 is minimum pass. Some use a regular 4.0 GPA. Check your transcript carefully.

How does the Switzerland grading system work?

Swiss universities use a 1–6 scale where 6 is the best grade and 4 is minimum pass. Higher numbers are better — opposite direction from Germany.

⚠️ Swiss scale uses 1–6 where 6 is BEST — opposite direction from Germany. Do not confuse the two.

Do the Philippines and Switzerland mark to the same standard?

No — and it is the difference in marking culture, not the arithmetic, that makes a direct comparison mislead. Here is how each country actually uses its own scale.

What a good grade means in the Philippines

The inverted scale is the single most consequential thing on a Philippine transcript sent abroad: a 1.25 is an excellent grade and a 2.75 is a weak pass, and an admissions officer reading it the other way round will draw exactly the wrong conclusion. Latin honours — summa, magna and cum laude — are awarded against these averages and translate far more reliably than the numbers do, so lead with them where you have them.

What a good grade means in Switzerland

The narrow 4-to-6 usable range is what makes Swiss marking hard to read from outside: only two points separate a bare pass from the maximum, so a 5.0 is a solid result rather than the mediocre "83%" it becomes if converted proportionally. Our own data previously treated everything from 5.5 upward as a top grade, which over-credited a 5.5 by a full band until it was corrected — the published scale distinguishes 5.5 as an A− from 5.75 and above as an A, and that distinction matters on a scale this compressed.

Will a grade from the Philippines get you into Switzerland?

We do not yet hold published entry requirements for Switzerland, so we do not compare your grade against a bar we cannot cite. The conversion above still tells you how your result reads in Switzerland terms.

1.0–1.25 (Excellent) → approximately 4.0 GPA.

What goes wrong converting grades from the Philippines to Switzerland?

the Philippines runs an inverted scale where 1.0 is the BEST grade, while Switzerland runs the normal way round. Reading a result from the Philippines as though higher were better inverts the conclusion entirely.

Mistakes specific to the Philippines grades

• Reading the scale as though higher were better. A 1.0 is the best possible grade and 3.0 is the minimum pass.
• Quoting a numeric average without saying the scale is inverted. This is the commonest misreading of a Philippine transcript.
• Omitting Latin honours. Cum laude and above communicate standing in terms any admissions office understands.

What should you do next, applying from the Philippines to Switzerland?

1. Check the course, not the country. Entry requirements are set per programme and revised every cycle. We hold no published national bar for this destination, so the course page is the only figure that binds.
2. Do not read the two scales the same way round. the Philippines runs an inverted scale where a lower number is the better grade, while Switzerland runs the usual way. This is the single most common misreading on this route.
3. Check whether an evaluation is even required. Unlike the US and Canada, Switzerland universities commonly assess foreign transcripts in-house. Confirm on the course page before paying for a report you may not need.
4. Get your documents moving early. Universities normally require your transcript sent directly by your institution rather than as a copy from you, which takes longer than most applicants expect.
5. Read both systems in full. How Philippines grading works · How Switzerland grading works

What do these grading terms mean?

GPA (Grade Point Average)

The US way of expressing an overall grade, on a 0–4.0 scale where 4.0 is the top — so a 4.0 is roughly what a 90–100% or a First Class would be elsewhere.

Percentage scale

A 0–100 marking scale — but the numbers are not comparable across countries: 70% is an outstanding result in the UK and a modest one in India.

Degree classification

A named band your final result falls into — First Class, 2:1, Distinction — used across the UK, Ireland, Nigeria, India and much of the Commonwealth instead of a single number.

Transcript

The official document from your university listing every subject you took and the grade you got — not the same as your degree certificate, and universities abroad want both.

Credential evaluation

A paid report from an approved company that restates your foreign qualification in local terms, which many US and Canadian universities require before they will assess you.

Credits / credit hours

A measure of how much a subject counts toward your degree — bigger subjects carry more credits and pull your average further.

Frequently asked questions